Fuel rail bolts

[jayroca]

Anybody got any extra fuel rail bolts lmw goin gen v intercooled and my fuel rails are held by my gen 3 top bolt and its not goin work thanks!

Sent from my SAMSUNG-SGH-I747 using Tapatalk

[machinegunsquid]

Do you mean the 4 that hold it do the LIM? Should be 3 studs on the LIM and 1 bolt. IIRC they should be M6x1.00

[jayroca]

Where can i get them from homedepot?

Sent from my SAMSUNG-SGH-I747 using Tapatalk

[machinegunsquid]

Let me go out and pull one off and check to make sure it's that size.

Does your LIM still have those 3 studs or have they been removed for some reason? If so, you should just need 3 nuts and bolt.

Give me a minute, its freezing here.

[jayroca]

Cool thanks man

Sent from my SAMSUNG-SGH-I747 using Tapatalk

[GTOorGTP]

If you have 3 studs and 1 bolt holding your fuel rail to the LIM.... it's had a stud turn out and that was replaced by a bolt..... from the factory there were 4 studs in ALL Series II and Series III FWD LIM's to secure the fuel rail.... no bolts securing the fuel rail to the LIM.

[machinegunsquid]

Yep, it's an M6x1.00

Check and see if you still have any studs in the LIM, if so, then just get 4 lock nuts, or 4 nuts and 4 lock washers.

If you dont have the studs for some odd reason, then get 4 bolts either M6x1.00x10mm or x15mm and just use a small dab of blue loctite on each.

Kind of a crap picture, but you can clearly see the 2 studs sticking up just infront of the IC core

[machinegunsquid]

And yes, any hardware store will sell them.

[jayroca]

Yeah I see em thanks machine gun where did get that oil cap I like that! Clean ass engine bay spic n span I tell ya!

Sent from my SAMSUNG-SGH-I747 using Tapatalk

[machinegunsquid]

No problem.

Oil cap is from Ebay. just search L67 oil cap, comes in a couple colors.

engine bay is actually pretty dirty. and that's my old pre IC setup (was used for mock up)

[jayroca]

No problem.

Oil cap is from Ebay. just search L67 oil cap, comes in a couple colors.

engine bay is actually pretty dirty. and that's my old pre IC setup (was used for mock up)

Old ic setup? Looks like your new one lol any pics of your new setup?

Sent from my SAMSUNG-SGH-I747 using Tapatalk

[machinegunsquid]

That was before I installed any of the IC stuff. It was my old LIM, valve covers, wiring, coil packs not relocated, etc. The IC core was just on to mock it up for clearances.

About how she sits now. Waiting to go under the knife again once it's warmer

[jayroca]

I'll check your build thread looking good hope to have her lookin like that by next week when I put my intercooler on reading your write up as we speak nice GTP what type of hose is that hooked up to your thermostat housing? Fuel pressure I see hooked up where did you get it at?

Sent from my SAMSUNG-SGH-I747 using Tapatalk

[machinegunsquid]

It's just a radiator hose sleeve, can get it at any auto parts place, cheaper online though, same for the fuel pressure reg vacuum line.

The previous owner had a port brazed onto the rail for the fuel pressure gauge.