Quote Originally Posted by drunknmunky View Post
thanks guys...


it took some trimming and all, but it really was quite easy... just as u said, VERY time consuming if u want it to look good, and not just thrown in there...



its quite simple actually... open ur console lid and remove the basket thing inside...
then start from the rear of the center console bezel, open the cup holders, and pull the bezel up... next i removed the shifter knob and plastic bezels for the PRND321... finally there are 6 screws that need to be removed... 2 10MM inside the cubby that u removed the basket from, 2 10MM holding the center of the console down (it is a silver L-shaped bracket, u just need to remove the bottom 2 bolts facing the ground) and finally 2 7MM (or phillips head) screws just below the ashtray... after that, just life the back of the console up slightly and pull towards the back of the car... (o and make sure u disconnect the electronics from in there, aux lighter, etc...)
don't forget to empty the cubby unless you like fishing stuff out from under the console too lol