This HOW TO write-up on making a Custom Cold Air Induction Air Box has been added to the How To section and can be found HERE.
|
|
01-11-2008
This HOW TO write-up on making a Custom Cold Air Induction Air Box has been added to the How To section and can be found HERE.
01-11-2008
nice write up !
01-11-2008
You sir, are a total badaz.
01-13-2008
Very nice
02-03-2008
Very Nice Writeup Dude!!!
02-03-2008
Looks exactly like my old MSP CAI, except the MSP is smoked of course. Nice job!
02-05-2008
Awsome Write up....I think I'm gonna make one, My buddy makes Lexan windows, so I can prolly get the lexan for very cheap
03-06-2008
interesting. could you also install some insulation like what is inside the Wizair intake? if so, what would that insulation be called? This could be a fun project.
03-06-2008
the lexan is alot more temp proof then the aluminum of the Wizardair, added insulation is most likely not needed
09-11-2008
will this setup work on my na 3800 gt
09-11-2008
Yes.Originally Posted by gtman98
09-15-2008
NEED INFO PLEASE!!
Have a 2001 GT, only Mod added is a Cold Air Intake, why at times, when you hit the gas hard (to the floor), car starts lagging and don't want to move unless yah let off the gas?????...........EXCELLENT SITE GENTLEMEN, KEEP UP THE GOOD WORK AND KEEP THE GRAND PRIX #1!!!!!!!!!
09-21-2008
Where did you relocate the computer to? I was going to do a custom CAI in my '99 GT but abandoned the thought after realizing the computer is housed in the airbox....
09-21-2008
Check the gaps on your plugs. More than likely one if not a couple of them are probably gapped way to big.
02-16-2009
For the top and bottom pieces, are the angles the same for top and bottom against the fender?
Also, what is the angle on the bottom piece that is 3 5/8"?
02-20-2009
any considerations for washing engine bay? i know that water is really bad for these, and i guess i am just wondering if the box is enough protection...
05-11-2009
Great write up dude. I plan to use your dimensions to make this box fairly soon because i happen to have a cone and some lexan sitting in my basement...I was also interested in how you chose to affix the PCM though. I plan to incorporate tie wraps some how... haha
what do you mean water is really bad for these? the K&N filters are washable! As long as you dont soak the filter while youre running the motor, theyre fine wet.
07-01-2009
how much hp does this add if anyy
07-04-2009
Were did you mount the ECM.
| « Previous Thread | Next Thread » |
| Tags for this Thread |
| Bookmarks |
Bookmarks |
