(MODS)Feel free to move this post if to far off topic.
I got my module back from Module Master last week and finally got a chance to install it today. Unfortunately the light comes back on once I hit 5-10 MPH still. I disconnected the battery for a bit even. All 4 wheel sensors checked out when I did an Ohms test(before I sent module in), well within spec and I spun the hubs by hand. Wires did not "appear" to be bad going up to any of the wheels either, but I will most likely be doing a Ohms test on each wire leading up to the wheel now. There's 105,000 miles on the car now. Does anyone have a pin out of the big and small plug that go on the EBCM? IT would be for a 2002 GTP, but others years may work as well. Any pin outs would probably be good to have in the first post/writeup too.
I noticed when I originally(and today) unplugged the EBCM that the big plug pin connectors almost looked rusted. I will try and clean them up to see if that could be the problem. Now, Module Master sent a receipt back with module which listed (can't think off hand) what was bad inside, but that could just be a generic statement that they send with all their modules. I hope it actually was bad, and I didn't just get charged $180 to "clean it up a bit" so to speak.
Any help appreciated.
