After doing my intake I found that the instructions were lacking a few details. Here are some things that may make it easier to make the intake.
1. I used white lithium grease to help the PVC pipe fit onto the rubber elbows.
2. A 1/2 inch drill bit works perfect for making the hole in the intake that air sensor plugs into.
3. When I got my PVC pipe I could only get it in a 10 foot length. I got mine at Men@rds and even though it was 10 feet in length it was still only $7.00.
4. I used a 12" conical air filter so I had to modify the instructions slightly. 14" for the longest piece, two 45 degree elbows, and a second 3 inch section.
I hope this helps anyone else who is thinking of doing this. With this communities help and little elbow grease its amazing what you can do.
