Well it did not work out very well I did everything you said fivefinger it seemed to be going well until I started jacking up the motor. The problem was I couldn't jack the motor high enough to get enough clearance to pull the mount out. I was barely able to lift it high enough to clear the studs that stick up out of the mount before I noticed the oil pan started to give in and then I stopped (I had a block of wood about 4x4x4 inches between the jack and the pan maybe it should of been wider to distribute the stress better). I still had to lift the motor about 4-5 inches more in order to have enough clearance to pull the mount out it just doesn't seem like the motor can be jacked up that high maybe I should've jacked it up by the trans oil pan instead for more leverage and used a wider piece of wood? Im slightly upset about the oil pan deforming a little but the damage seems to be cosmetic only (I hope)
