my ported blower/alky project

[SyntheticShield]

What did you use to close those slits up Bio? How much confidence do you have its going to stay in place?

[Bio248]

What did you use to close those slits up Bio? How much confidence do you have its going to stay in place?

i used an aluminum epoxy that i got from NAPA. it starts as a puddy that you knead together the middle and outside and then after you let it sit it gets rock hard. im not worried about it going anywhere because the slots are angled so with the LIM being pressurized they are actually getting an upward force on them. i dont think they are going to go anywhere anyway.

if they do, then so be it. then i get to get a new motor. a better motor.

what about polishing the rough spot in the middle of the casing? would that show any better flow? but other than that it looks good mang! and im with scotty. what did you use to fill those areas?

i dont think polishing the rough spot is going to add or subtract anything, so im going to leave it. i really dont want to touch anything on the inside of the casing anyway.

Looks good. I suggest you get it one so we can here it whine. I want to here one with the slits plugged.

youre telling me man, i want to hear it too. too bad i have no video camera to take it with. my phone probably wont do it justice.