Firstly, I'm using HPT... Took me 3 or 4 days to make the sweet config file I'm using
Maf disconnected, PE disabled - All data is logging correctly and accurately, Problem is : After adjusting my VE table,
which is lean by 15%-20% at low rpm, I flash the new adjusted file then re-record...
It stays the same... Or worse, it runs even more lean! wtf is going on here?
At 2,800rpm/30kpa, I have 1.23. I multiply that cell by 1.23 and on the next dyno pull, it went to 1.27 lol
anyone?