Well they seemed to seat just fine I was just worried about thread tolerance I wouldn't think they would change, but those damn Chinese can't get anything right.


Quote Originally Posted by Booba5185 View Post
I knew it was a lot when you were talkin about it, lol. Pretty crazy that you literally had to MAKE the tool to do it, lol.
Yeah, I was pretty busy I even had to eat McDonald's since I was starving and wasn't going to be getting out of there anytime soon. Luckily with both of us doing the work, and that tap not being hardened it was a lot easier and faster than I thought it was going to be., that and the hole for the rod ended up being a perfect fit. Usually they try to move around and you end up with a larger hole than what you drilled so I just stepped up from 1/4 to 5/16 then to 3/8" I was afraid I was going to have to go to 1/2" since that's the only other rod we had in stock besides tube.

I'll try to knock out the timer this week it's been crazy busy and I have been on the phones most of every day. Luckily I can type and listen at the same time lol.

Jeff