lol so out west cause there is hardly any snow around here. have u even rode it this year yet?
Printable View
lol so out west cause there is hardly any snow around here. have u even rode it this year yet?
Nope. Sat in my garage with the cover over it all winter. I have maybe 2 inches of snow on the ground.
haha that sucks!! we got maybe 6 inches here
I would probably bring it out if I had 6 inches here. Only until the trails got ripped up.
Go to PM's...
yea witch wont take long. thats y i got a atv ;)
Lol, mods are mad. Oh well.
I don't know if I told you about my buddies 660 Raptor, but it sounded like a mentally handicapped child with a triangle and beat it into a circle. We took the head, cylinder, piston, and the sides off the engine last night. He still needs to split the case to get the crank out. But.... head looked good, sending it off today. Cylinder was ehhh, took forever to get the cylinder out. Well the cylinder oil ring was flattened, cylinder wall was loaded up with aluminum, and a major scoring on cylinder wall. Wasn't till later I found that part of the piston head skirting was missing. The conrod had so much deflection.... you could literally wiggle it a good 1/8" both ways, and up and down. Never seen the piece of missing skirting, but may have found where it was at one point. Took the side off w/ the clutch pack, clutches were wornish. On the outside of the clutch pack assembly was scoring, and scoring on the inside of the side cover. Still never found the piece, but head is getting sent of for P&P, and hes gonna order all the new parts he found were jacked up. Order the stroker kit and split the case... woot! This thing is going to be stupid expensive and stupid fast when it's all done. Oh and he needs new engine mounts and nerf bars. They were both ****ed up when we took them out.
Hmmm Sell my opened and never touched gopro..or start showing you how a grizz plows ... oh wait. That requires snow. forget it, snow has been cancelled this year.
Cannot wait for wifi bacpac!!!
haha u should just tell ur friend to put a R1 motor in it :)
His brother has a R1 that his brother wrecked. It was only minor so he is rebuilding it.
anyone have a hero3?