No grease zerk on your tie rod end?
|
so I had to make a hole in the throttle body and in the intake so it will bolt up, use the Dremel on the inside to make the spot where I wanted the whole to go and then a drill bit
ordered all the rest of the stuff I need for the build pretty much except for one or two small things
getting ready for a little bit of body work tomorrow
it's not too hard you have to move the battery to the trunk take the fuse box and move it where the battery was, I had to tap the throttle body and the intake so the one bolt on the throttle body would line up, you need a 98 alternator and bracket but it's not to bad, and right now it's just going to keep the pre gens
But now you'll have to drill it out of get another intake.
MMMM...custom intake.
Just an advice, may want to ditch the worm clamps and upgrade to v clamps for the intercooler pipes and couplers.
« Previous Thread | Next Thread » |
Tags for this Thread |