|
Last edited by Timing; 09-20-2013 at 11:50 AM.
lucky you see how your 02 is right before you exhaust hangar my 02 goes right in between the rubber 0 ring what a bad spot whats so bad about the hydraulic fluid in the mounts not sure if I should replace my mounts or not engine doesn't seem to move since I put the upper polys in
press on brake
put in drive
try to go foward
if you hear knock your mounts are bad
Looks good homie let me ask.you about my engine mounts if I'm in drive two and at low speeds like under 2k and tap the gas feel a klunk like if engine or tranny shifts is that what u .mean by bad mounts ? But its only at low rpm.
Yea but I have polyurethane mounts in the dog bones they don't .move ill see what's up woth the bottoms tomorrow
Sounds Good...that was a nice little drive.
Wish I could get a tune from one of the big dogs......with-out having to drive to mars.
Car is a little violent sounding, do you have a res?
Starting motor mount
Welded in rods
Didnt have enough polly for both so im ordering 2 more this week. If you decide to do this ide grab 3-4 to be safe.
http://www.energysuspensionparts.com...sp?prod=DIYMMI i got the 94A
Not to be a Debbie downer by why didn't you just make some like 91parkave?
« Previous Thread | Next Thread » |
Tags for this Thread |