|
|
12-19-2013
I was replacing my thermostat and I broke two vacuum lines... I found someone else that did it and he outlined the picture to show what lines they are... I want to replace these lines, here is the picture http://www.2carpros.com/questions/19...-part-name-for ... thank you.
12-19-2013
Fuel pressure regulator/evap canister purge valve line??? is that what it's called?
12-19-2013
if its just the line there thats cracked in two, you can put 1 inch piece of vac tubing to join them back together.
12-19-2013
they both cracked off right at the piece where the two lines join together.. right where it meets the intake. i did my best to superglue them back on but idk if that would be permanent lol i rather replace it if I can.
12-19-2013
i dont know what that large part looks like when the lines are off there, on the right side. if its a round port you can put a fat vac line then a smaller one inside it, then a T on the end, then connect the two lines with vac line to the T.
12-19-2013
when the large part is off it's just one hole that both these lines go into. I could probably get a T and connect it.. the 2 lines aren't classic rubber, they're hard.. idk if that will make it more difficult. i wish i could just find the lines online.. but there doesn't look to be any.
12-19-2013
the hard lines, you just push them into the vac line. its a permanent repair.
this is how i fixed my evap line when it broke, the fat line from the side of the TB that turns to the back of engine, with a smaller line pushed inside it, then to the plastic line.
| « Previous Thread | Next Thread » |
| Bookmarks |
Bookmarks |
