|
|
01-16-2013
my abs and traction control light came on so i replaced my wheel bearing and the lights went off, about a week later they would come on and go off and now they are both on again, i hooked it up to a scanner and it says its my wheel speed sensor, i bought one and i heard that there are 3 of them is this correct? and how do i find out which one needs to be replaced?
01-16-2013
The code is usually specific to which one is bad.
Odds are the wiring running from the wheel bearing to the ebcm is bad. Just an fyi The wires MUST be twisted. Always find the fronts going bad.. Don't recall ever doing a rear.
Sent using my Galaxy SIII on Tapatalk 2
01-16-2013
i cant remember what the code was i beleieve it was b00 something or close to that,
and also i got to work today and my blower fan would not turn off had to disconnect my battery for now and ideas what that might be?
01-16-2013
Do you have the auto hvac setup?
Sent using my Galaxy SIII on Tapatalk 2
01-16-2013
yes i do
01-17-2013
The auto hvac setup has doesn't have a resistor but instead a blower module if I remember correctly, and they are known for going bad.. Well known to continously run.
Sent using my Galaxy SIII on Tapatalk 2
01-17-2013
Yup the blower control module!
| « Previous Thread | Next Thread » |
| Tags for this Thread |
| Bookmarks |
Bookmarks |
