|
|
12-05-2012
hi guys,
i know how to adjust them but i was wondering if there was a trick to get them to factory alignment.
For example if i tighten the screw all the way and then make 3 complete turns does that bring me to where they should be? i would like to try that before i play with them and choose a preference. Right now they are too high. Thanks
12-05-2012
Figure at 40-50 feet on a wall, they should be thigh high maybe.
12-05-2012
stock headlights dont even shine that far
12-05-2012
what if i can only get my headlights like 15 feet from the wall if that lol
should i find another wall?
12-05-2012
Go to any grocery store, dept store etc at night and use there wall...
12-05-2012
a cliff, if you see your headlights point down you went to far.
12-05-2012
yeah i could do that. at least i have something to aim for as far as correct position huh hurtz? lol
12-05-2012
12-05-2012
i read before it pull up to the wall and beams should be level with reflector, put a piece of tape on the wall right where the beam is, pull back 25 feet and the beam should be at or up to 1 inch below tape, dont quote me on this, but this is how i did mine and they light up the road pretty well and i dont get flashed lol
12-05-2012
this should not be that complicated lol
12-05-2012
hey, seeing at night is worth the complication, and it took me about 5 mins to do, not that hard lol but it worked perfectly and i have no problems.
12-06-2012
I just installed new headlight housings in my GTP last night. Afterwards, I took it out to an empty road with no cars and sighted them in on the road with both high and low beam comparisons.
| « Previous Thread | Next Thread » |
| Tags for this Thread |
| Bookmarks |
Bookmarks |
