Ok new halfshafts and hubs and new tires, all vibrations are gone!!! New problem is when i put car in reverse it clunks, so is this a bad shaft out of the box or was the bad shafts masking the other problems of bad mounts??? Only does it in reverse and the sound sounds like splines lighning back up but when installing the shafts the splines where good and tight thats what brings me to this. Ive done some reading on old post but just asking again, i have already done some things in posts that i have read but ive not experianced any sound like this in any car i have worked on but this is front wheel drive too, soooo its a little new to me so im in the learning curve.