Thread: So went to put my filter on...

Originally Posted by Bio248

at least a dry one i can take 2 minutes and blow it out with my compressor and be done.

This.

But as I said earlier this morning I have the K&N on now so its ok.

Originally Posted by tayl5645

If your worried about the PCM placement what I did was took the stock airbox and just cut where the filter was before right off (only do this if your not going back to stock filter) Then I still had where the PCM clipped in before and could securly attach it to the car. While allowing the filter to still flow freely

ok the reason im on this thread is becasue, im trying to zip tie my pcm because its rattleing around and is super loud, im also in the process of tieing down my hid ballast too, and i did the same thing ask mentioned above and cut the bottem of the box off so i have the pcm tray part but question is how do i zip tie it down or secure it down so it doesnt move, thanks

The bottom of the airbox should just snap in.

the tray thing pops in, but it doesnt stay and the pcm moves around on top of it, so im just trying to keep the hole thing from moveing and bouncing around

PCM snaps into the tray also. And are you sure you got it in all the way?

i pushed the tray i all the way, i think maybe i dont have it lined up all the way, and the pcm doesnt snap in it just sits there, is there some plice that makes it snap in that im just missing