|
|
11-29-2010
Ordered a kit from intense for a coupler change. Im very impressed with these guys, they are always willing to answer all my questions and are very helpful. One of the guys said if I was going to change the coupler to try and not tear the gasket to the superchager. Now I have not ever changed one of these only watched youtube videos, I didnt even know that was possible? Im a little spooked about doing this now, any suggestions??
11-29-2010
They mean the gasket that is between the blower and the manifold. Just be careful when you take it off. Try to get the oil out before you take the snout off too otherwise it'll be messy.
11-29-2010
I would just get a new supercharger gasket.
11-29-2010
Wouldnt thst mean I would have to take the superchager off? I thought I could just take the snout off?Originally Posted by 01GTP
11-29-2010
Got ya
11-29-2010
you dont have to remove the SC to change the coupler. the snout will come off and you dont have to mess with the SC Gasket
11-30-2010
lol why does your sig say inercooled? did u mean INTERcooled?
11-30-2010
Most of the time the gasket is fine. Technically as long as it doesn't break under the charger, you don't need to piece under the snout. Sure there's a little difference in height.. if that's taken care of where the bolt is.. you are all set.
I've always had great customer service from Todd and the guys.
| « Previous Thread | Next Thread » |
| Tags for this Thread |
| Bookmarks |
Bookmarks |
