Thread: begining to overheat

Results 1 to 17 of 17
  1. #1 begining to overheat 
    GT Level Member mezzoni's Avatar
    Join Date
    Nov 2009
    Location
    Milford, CT
    Posts
    379
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    so i notice some odd noises coming from my car, swear under my breath a couple of times and keep driving. about 10 minutes later at a stop light i notice my temp. is up to about 245-250. HOLY SH!T so i start to drive and it instantly cools down to about 215-220ish. long story short it stayed pretty much between 210 and 250 between stop and go, 30mph, and 70 mph on the highway. and it would flucuate like crazy. i can look at it for literally no more than 10 seconds and it would go from 210 to 250 or viseversa. now for about the last week my low coolant light has been coming on but didnt when i noticed this happening. so obviously time for a coolant flush/top off but is it possible a sensor is bad or i have more issues beyond just these?
    2006 pontiac G6 GT coupe - the daily
    2001 pontiac trans am WS6 - pacesetter headers, slp exhaust, diablo sport tuner, ported throttle body, ported MAF, SLP intake lid, B&M shifter, UMI panhard bar, lowered on koni's
    Reply With Quote  
     

  2. #2 Re: begining to overheat 
    Turbo is the way to go. Fivefingerdeathpunch's Avatar
    Join Date
    Sep 2009
    Location
    Rogers, MN
    Posts
    21,030
    Thanks (Received)
    21
    Likes (Received)
    45
    Dislikes (Received)
    0
    low coolant or air in system are my guess's

    SMGPFC Member #1
    Reply With Quote  
     

  3. #3 Re: begining to overheat 
    GrandPrix Junkie machinegunsquid's Avatar
    Join Date
    Sep 2008
    Location
    Florida
    Posts
    3,759
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    Yep, mine did that earlier this week, GF was driving the car, and a hose broke (overflow hose) which let coolant leak out whenever it was at operating temp (usually 185ish)
    I took it for a spin after putting a new hose in it, and it did the same thing you're talking about.

    All I did was flush the system, and fill'er up, and its been perfect since.

    "**** bills. You can live in your car but you can't race your house" -dsmuts
    Want her to stop when she's not looking karate chop her in her crotch that should quiet her for a bit or at the very least put a smile on your face -REDCOMPG
    Reply With Quote  
     

  4. #4 Re: begining to overheat 
    GT Level Member Jakescoots's Avatar
    Join Date
    Aug 2010
    Location
    Spring Lake, Mi
    Posts
    453
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    there is an elbow that commonly blows out that has coolant run through it
    Reply With Quote  
     

  5. #5 Re: begining to overheat 
    GT Level Member mezzoni's Avatar
    Join Date
    Nov 2009
    Location
    Milford, CT
    Posts
    379
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    my dad said to flush it but to bring it somewhere and do it so it looks like thats what i'll do. and there must've been a leak because there is sealent dumped in there from the previous owner. im just gonna bring it somewhere and have it done so it gets everything flushed out, in the block and stuff, not just the radiator. is that what you did? i just dont wanna spend the money
    2006 pontiac G6 GT coupe - the daily
    2001 pontiac trans am WS6 - pacesetter headers, slp exhaust, diablo sport tuner, ported throttle body, ported MAF, SLP intake lid, B&M shifter, UMI panhard bar, lowered on koni's
    Reply With Quote  
     

  6. #6 Re: begining to overheat 
    The mod from over yonder TheOtherNick's Avatar
    Join Date
    Sep 2008
    Location
    Charles City, IA
    Posts
    9,955
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    Try bleeding the system first.
    01 gtp-big cam e85 dd 78dodge- guzzling fuel 05 cummins- rollin coal
    SMGPFC Two Nipple General
    Reply With Quote  
     

  7. #7 Re: begining to overheat 
    GrandPrix Junkie machinegunsquid's Avatar
    Join Date
    Sep 2008
    Location
    Florida
    Posts
    3,759
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    No, I did mine myself. I used a high pressure hose attached to a heater core line, with the heater on full blast. It cleans everything out really nice, and is essentially free.

    "**** bills. You can live in your car but you can't race your house" -dsmuts
    Want her to stop when she's not looking karate chop her in her crotch that should quiet her for a bit or at the very least put a smile on your face -REDCOMPG
    Reply With Quote  
     

  8. #8 Re: begining to overheat 
    GT Level Member mezzoni's Avatar
    Join Date
    Nov 2009
    Location
    Milford, CT
    Posts
    379
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    well heres the update so far, i poured in a bunch of coolant, the temp. problem seems for now to be fixes. it didnt top 210 at all and was mostly at about 190 or so.however the noise is still there and seemed to have gotten a little worse. its a really weird sound, its almost like i tick or a tisk its really hard to describe tho. you can hear it at idle with the hood up and if your looking at the engine it sounds like its coming from the back left, so by the belt. my dad said it might be my power steering pump, which has always made noises but that i think is just because the fluid was a little low. when im driving its loud enough to hear from inside the cabin and i noticed when i accelerate or am on the pedal it seems to get a little bit louder. any idea on what that can be?
    2006 pontiac G6 GT coupe - the daily
    2001 pontiac trans am WS6 - pacesetter headers, slp exhaust, diablo sport tuner, ported throttle body, ported MAF, SLP intake lid, B&M shifter, UMI panhard bar, lowered on koni's
    Reply With Quote  
     

  9. #9 Re: begining to overheat 
    SE Level Member chev1988rolet's Avatar
    Join Date
    Jul 2010
    Location
    TX
    Posts
    122
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    if its a tisk it could be an exhaust leak from flange or loose spark plug wire or spark plug on rear bank of engine
    Reply With Quote  
     

  10. #10 Re: begining to overheat 
    GT Level Member mezzoni's Avatar
    Join Date
    Nov 2009
    Location
    Milford, CT
    Posts
    379
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    the thing is its not constant, wouldnt that be constant? and i doubt its a exhaust leak my fuel mmileage hasnt dropped of any
    2006 pontiac G6 GT coupe - the daily
    2001 pontiac trans am WS6 - pacesetter headers, slp exhaust, diablo sport tuner, ported throttle body, ported MAF, SLP intake lid, B&M shifter, UMI panhard bar, lowered on koni's
    Reply With Quote  
     

  11. #11 Re: begining to overheat 
    SE Level Member chev1988rolet's Avatar
    Join Date
    Jul 2010
    Location
    TX
    Posts
    122
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    depends on how much its leaking. you can take the belt off and turn on the engine. if it still makes the noise then you know its none of the accessories. you gotta think of the part of the engine that would make a ticking or tisking sound. Does the computer throw a misfire code?
    Reply With Quote  
     

  12. #12 Re: begining to overheat 
    GT Level Member mezzoni's Avatar
    Join Date
    Nov 2009
    Location
    Milford, CT
    Posts
    379
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    i dont know, how do i even get that checked? just go to autozone and say "hey, scan my car for a code" ? is that a free service they offer?
    2006 pontiac G6 GT coupe - the daily
    2001 pontiac trans am WS6 - pacesetter headers, slp exhaust, diablo sport tuner, ported throttle body, ported MAF, SLP intake lid, B&M shifter, UMI panhard bar, lowered on koni's
    Reply With Quote  
     

  13. #13 Re: begining to overheat 
    GT Level Member mezzoni's Avatar
    Join Date
    Nov 2009
    Location
    Milford, CT
    Posts
    379
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    btw, the check engine or service engine soon light is not on
    2006 pontiac G6 GT coupe - the daily
    2001 pontiac trans am WS6 - pacesetter headers, slp exhaust, diablo sport tuner, ported throttle body, ported MAF, SLP intake lid, B&M shifter, UMI panhard bar, lowered on koni's
    Reply With Quote  
     

  14. #14 Re: begining to overheat 
    SE Level Member chev1988rolet's Avatar
    Join Date
    Jul 2010
    Location
    TX
    Posts
    122
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    Yea just ask them to check your car for codes. and the light isn't always on when a code is stored in the memory
    Reply With Quote  
     

  15. #15 Re: begining to overheat 
    GT Level Member mezzoni's Avatar
    Join Date
    Nov 2009
    Location
    Milford, CT
    Posts
    379
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    oh alright thanks for the pointers my man ill be sure to do it
    2006 pontiac G6 GT coupe - the daily
    2001 pontiac trans am WS6 - pacesetter headers, slp exhaust, diablo sport tuner, ported throttle body, ported MAF, SLP intake lid, B&M shifter, UMI panhard bar, lowered on koni's
    Reply With Quote  
     

  16. #16 Re: begining to overheat 
    GTP Level Member SnowDrift's Avatar
    Join Date
    Apr 2009
    Location
    Central Ohio map dot.
    Posts
    802
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    If not an exhaust leak, then it could be a lifter ticking - not too uncommon after several years of service if the valves haven't ever been adjusted. Not sure how easy it is to do on these motors, sitting in there sideways, but you might try to pop the valve cover off you're hearing the noise from and start the engine to see if you can isolate it. If you're not comfortable with that, then find out what the torque spec. is for the rocker arms and torque as necessary (this is a much cleaner way to do it, if you can).
    Reply With Quote  
     

  17. #17 Re: begining to overheat 
    SE Level Member
    Join Date
    Feb 2009
    Location
    Boston
    Posts
    19
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    EGR Valve. Plenum needs to be replaced possibly. If it starts chugging coolant... that's your problem.
    Fiske
    95 Taurus SHO ATX - 121K
    99 Audi 2.8 Quattro - 113K
    99 Grand Prix GT - 83K
    Reply With Quote  
     

Similar Threads

  1. 3.1 overheat
    By basmatic in forum General Tech Discussion
    Replies: 2
    Last Post: 03-08-2010, 05:07 PM
  2. 2000 grand prix overheat
    By dabatman99 in forum 3.8L V6 Naturally Aspirated (L36)(L26)
    Replies: 12
    Last Post: 11-05-2009, 06:36 AM
  3. SQ Build... the begining
    By JCG's-GTP in forum Audio, Security & Visual Electronics
    Replies: 5
    Last Post: 06-28-2008, 07:28 PM
Tags for this Thread

View Tag Cloud

Bookmarks
Bookmarks
Posting Permissions
  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •