OK my wife just got back from the dealer to have the recall valve cover gasket done. They also did a 27 point check on the car and found that it needs an LIM. I have already done this once about 50-60K miles ago (fel-pro gaskets). I just watched the tutorial vid in the how to section and read the thread (great job on the vid btw). I read towards the end of the thread that the plastic gaskets (which I used at the time) only last about 50K. Is that right? My question is what is the best brand to use so I dont have to do this again? I read that there is an aluminum set out there. Does anyone have the part number and or brand? I plan on tearing this thing down this weekend and doing it. Also while I am in there I will be doing a complete tune up. I suppose I should do the rear valve cover also. Any suggestions or advice would be greatly appreciated. She is going to be driving this car from Connecticut to Oklahoma in a couple weeks and want to be sure everything is tip top before she hits the road. It is a 2000 GTP with 128K.
