hid conversion install

[grandprixgt]

where did u guys with hids put the both ballast and the pos./neg. on the drivers side cant find a pos./ neg. on the drivers side for ****

[dagger]

the ballistics fit just under the plastic bumperon the crash bar. I used double sided sticky tape to keep them there and almost couldn't get them out when I needed to move them a bit ha ha ha.

As for the positive and negetive I just straight up used the positive and negetive sides of the battery terminal. I got crap connections else where.

[grandprixgt]

the wires i got are to short to reach the battery so i would have to splice and connect extra wire in order for it to reach

i got the mcculloch kit here is all that came with it
2 ballast 2 single beam bulbs 2 ignitors and zip ties

[grandprixgt]

nevermind i got it...it was all plug and play lol

[vailskier3]

i was gonna say...mine were just plugged straight up...no need to get to the battery...

[grandprixgt]

lol yea i didnt have to connect anything to the battery i figured that out after i sat down and put it all together and looked at them lol i was like oooo...but i got the single beam...do u know if i can just but the bi-xenon bulbs or would i have to buy the whole bi-xenon kit


finish project

[vailskier3]

i would just stick with that, because if you flash your brights, it wont even have enough time to turn them on fully, and that can burn up the bulbs, you might as well go with like a silverstar ultra in your high beams so they look close, but if you really want to...you can just buy another single kit for your high beams. don't buy just the bulbs if you do this, you need the full kit.

[grandprixgt]

i would just stick with that, because if you flash your brights, it wont even have enough time to turn them on fully, and that can burn up the bulbs, you might as well go with like a silverstar ultra in your high beams so they look close, but if you really want to...you can just buy another single kit for your high beams. don't buy just the bulbs if you do this, you need the full kit.

o ok i dont really need the high beams though just wanted to know thanks for the info