Thread: Blower motor cover install w/pics also fixed my DIC

I got the part yesterday and decided it was warm enough to do it today. I followed the write up and it took about 15min..it was too easy. I wish it would of taken longer because I like doing things like this.

After a long and hard winter it got a little dirty but I'll get it looking like new soon enough.


I started undoing the clips and moved the solvent tube out of the way.


When I pulled off the cowel this is what I found...the seal was laying over the opening


After installing my new peice.


Done!!


These pictures were taken with my cell phone so I'm sorry about quailty and size.

Edit**

I just got back in from tearing my dash apart and replacing 3 blown bulbs in my DIC. It's much brighter now, I'm pleased with the results.

Good pics, there is a how-to-section that covers this. I would recommend posting this in that thread as well, a couple more pics couldn't hurt for others who will need to do this.

why did you install a new one? you could have just used silicon to make the old one stay where it should be.

Originally Posted by Bio248

why did you install a new one? you could have just used silicon to make the old one stay where it should be.

The one he installed creates a shield vs. the stocker which allows water to run down on top of the motor IIRC...