|
|
02-27-2015
Whats a decent price for a set of 04+ heated leather seats? i got my cloth set from a 05 for 75$ from my junkyard, but i have heated seat function in my 01 and am thinking about wiring it for passenger side too.
I got the rims off that car today for 150$, two tires are 1/4 tread, and other two are like new. I got offered 150$ to take the set of seats but theres about a nickel or a little smaller than a quarter size burn hole in passenger im not sure if its worth it
02-27-2015
150 is a great price imo. In my area people try to sell just the fronts for 250.
Originally Posted by BoostenGTP
02-27-2015
The seats looked decent, besides the burn hole. Im thinking i can get these for 150, then ask 200$ for my set of cloth thats in my car now. i can get any other part off the car besides engine/tranny. Im thinking literally next to nothing for most of it. The rims are 100$ each normally and i got a set and decent tread of them. Im ganna throw them on my car this week mabey matters if they are good in snow or not
02-27-2015
Sounds like a good price. I got my set of leather/suede 05 GXP seats for a touch over $300 (both front and rear seats). With what you are paying you could recoup your $$ for most of it. The burn hole may be able to be repaired by an upholstery shop.
02-27-2015
Sweet I should be able to sell my old cloth ones. I'm just thinking how am I ganna fit it in my car. I may have to remove the passenger seat then go and get them and put one of new seats there
02-27-2015
No friends that own a truck? I suppose if you removed the pass seat and the entire rear seat you could get it home that way. Either that or find someone to drive their car there with you and split them up into 2 cars.
02-27-2015
I put all the seats and carpet from a 3000GT in my Grand Prix before and didn't remove anything from the Prix to do so.
02-27-2015
I know when I got my cloth I had to make a second run to get the other front seat. No truck to use pretty sure I'll be able to fit them if I remove the passenger seat
02-28-2015
Remove the passenger seat and I would go ahead and remove the rear seat your going to have to remove them anyways to swap them out save yourself a second trip just in case.
Sent from my iPhone using Tapatalk
02-28-2015
Remove the rears and then when you get there "install" the rears and then 69 the two front seats. It'll be tight but it can be done
Originally Posted by BoostenGTP
02-28-2015
I see. I was going to remove passenger seat then remove the bottom part of the rear one. I still have not gotten the bottom rear seat to fit right have to get the clips right and have been really lazy
03-02-2015
I got my seats for $130, only to find out a closer boneyard finally got their own GT2 and would sell them for half that! I might take them up on the driver's seat, though; besides the hide not being best of breed, the seat is 2-3" too close to the console! I can't figure out how or why it's out of whack; the rails easily dropped in (relatively speaking) and the headrest is level. It's just... a little closer to centre than it should be! Are there lateral adjustments I can make to the track, where it bolts to the seat? Or is this expected?
| « Previous Thread | Next Thread » |
| Bookmarks |
Bookmarks |
