i got my 25 door panel clips in the mail because a lot of my clips had broken and the panels were just hanging there. on the passenger side door, i started by removing the two torx screws from behind the handle as i thought that would be the most difficult because i didn't have any tor bits lying around, or so i thought. anyway i found one that fit the screws so i unscrewed those and boom, first one falls down inside the panel. no big deal i thought cause i have to take the panel off anyway. well the panel i tried taking off didn't have any broken clips, i was just gonna do it to put some new ones on so it wouldn't break in the future. well i couldn't get the panel off no matter how hard i yanked (you know what i mean). i gave up on that and that one screw is still inside the door panel so only one is holding it on but thats enough, i pulled on it and it seemed good. oh and i couldn't get the door lock switch connecter undone to remove the lock and window assembly in the door. so i move to the rear passenger door now. this panel had at least 3 broken clips. since some clips were broken it was easy to remove the door panel. replace the clips and realize yet another screw fell down after i put the new clips in. well in the procedure to remove the panel with new clips, the new clips were frustratingly hard to remove and i broke a couple. well again i only i got one screw in by the time i finished so now the whole passenger side of the car has only 1 screw holding the door on per door. and it took over an hour to do half of the car. mmmcmmm i feel stupid and wasted a ton of time. FML
