I had better get an aeroforce gauge for my truck then huh lol
Printable View
I had better get an aeroforce gauge for my truck then huh lol
Little insight. I should of noticed 2 months ago it was going to fail. At idle I'd hear a pop and now I understand it was that intake valve from DoD lifter going bad not opening all the way. Luckily the second it collapsed I was in the parking lot and turned it off. Didn't cause any further damage.
Sent from my HTC6525LVW using Tapatalk
Got all the parts needed to put the bonneville back together and fixed a brake line on it. I'll be replacing the other 2 broken brake lines when I feel like it and putting all back together.
http://tapatalk.imageshack.com/v2/15...f545e3b77d.jpg
Reset it for my trip back to school driving up and down hills and into the mountains and stuff. Had cruise on 64 most of the way and managed to pull this. This is the best I have ever seen and was shocked I know partially cause of coasting and stuff but previously the most I ever pulled was 27.5 after a reset and I know the dic isn't that accurate but it was just exciting.
Also cleaned out all the trash
If it were supercharged that number would be about 6 mpg lower. LOL
I have 2.93. The problem is superchargers love to build boost while climbing hills which sucks the fuel down.
I got over 28 mpg with no tune on my trips to Norwalk, OH with lots of town driving mixed in. I got less than 23 mpg on my all highway trip to Virginia because of hills/mountains.
^^Yep. From a MPG standpoint, I always loose a little speed going up the hills and get it back on the downhills, and get a running start at any hill you can. Most of the time I don't care enough and let cruise control do it all.
I left a milk crate in front of the GTP and when I pulled out of the garage. Crack goes the bumper. OOps. I guess that is what I get when I don't drive a car for a while and I just pull it out of the garage.
http://i.imgur.com/9krCVYK.jpg
http://i.imgur.com/pxsH8bc.jpg
http://i.imgur.com/Q79m7aQ.jpg
Still have some work to go, but I will get it her looking good again.
http://i.imgur.com/Q79m7aQ.jpg
Lol, you work fast, that's for sure.
Detailed the engine. Gave her a hand wash. Flashed the PCM. That is all.
it got a little dirty on the out side. engine leaked oil on the plastic we had down, so that the move of the day.
Damn that Kyle!
my guess it came from the oil filter housing area, or that sketchy filter.
Didn't you clean the gasket surface?
Too cold I bet