Located in Lansing Michigan. Best way to reach me is to email chinson46@gmail.com
I have 2 spare sets of ported heads. One was a custom build for a customer who backed out. The other is a set I finished in my spare time between work.
Both pairs have at least the following work
>Head casting cleaned and checked
>Cleared for 550 lift & with new seals installed
>Exhaust runners reshaped, polished and opened up throughout
>Exhaust bowls blended and polished
>Intake entrance gasket matched
>injector bosses taken down
>Intake runner reshaped and opened up throughout
>Both side short turns reworked
>Primered and painted with high temp engine Enamel
The better 1 of the 2 pairs has
>Polished combustion chambers
>Intake bowls reshaped
>Intake bowls blended and polished
This set was built for a guy who backed out. They can be had bare with new 510 Viton valve seals for $400 + shipping. If you would like, I can reinstall new 105 or 130# valve springs with new Manley lightweight retainers for the cost of parts. Please remember these are cleared for 550. If you are running a larger cam, I will have to mill to guides down for you.
The second pair, Same deal. I've been using these to practice port designs. they have taken numerous trips to the flow bench with very good results. These are similar but have polished CC's and blended intake bowls. Asking 500 bare.
