Wire harness diagram

**zacaschenbach007** · 04-11-2016

Anyone have a wiring harness diagram for a 2002 gtp engine bay?

**Fivefingerdeathpunch** · 04-11-2016

What part though?

Because the engine bay has engine, trans and ABS wiring in there. Might be easier to narrow it down by what sensors you are looking at.

**zacaschenbach007** · 04-11-2016

All of the above to be honest

**zacaschenbach007** · 04-11-2016

Engine to start with

**Scottydoggs** · 04-11-2016

whats the back story here? the plugs all only fit one place, and will fall in place pretty much.

**zacaschenbach007** · 04-11-2016

Did an engine replacement. All I want is a diagram of where everything goes on the bottom

**Scottydoggs** · 04-11-2016

theres not one that i know of, like i said, all plugs can only go one place, once you lay the harness over the engine all the plugs will have its home with in three inches or so of where the harness lands.

**Burbman** · 04-12-2016

The wiring diagram will be a schematic, not a routing map, have to use common sense there.

**thebrandin** · 04-21-2016

I'm looking for something similar, wiring schematics. I'm swapping an L67 into a Chevy C10. After researching the block stamp (24502287) I found out it came out of a '96. What car I have no idea. If I'm going to have to wire up this motor and PCM one wire and pin at a time, any help on anything electrical would be greatly appreciated. Also, if anyone knows how I can find out what car it came out of that would be awesome.