|
|
12-29-2012
I have a 2004 GP gt. when i bought the car i knew a wheel bearing was going out. I ended up replacing both fronts with new timkins. Well just recently my car threw an ABS and Trac code. I put my scanner on it and it said it was the left front wheel speed sensor. I replaced the wheel hub again and the light still comes on even after i clear the codes. Im at a loss for what i should do next. Any help??
12-29-2012
check the wires real good from the plug at the hub to the main harness, they are clipped on the lca's and can get damaged, look for cracks in the insulation, or a a clean break even.
and clean the plug socket, then dab some di-electrical grease on it.
12-29-2012
Alright ill try that. I just got the abs code which is: C0035
12-29-2012
bad wires will throw the same code. its free to look at them...
12-29-2012
fishman like scotty said check the wires leading to the plug. I had one go bad on my 07 near the middle of the car. on a separate not what part of muskegon are you from i used to live there and got family there.
| « Previous Thread | Next Thread » |
| Tags for this Thread |
| Bookmarks |
Bookmarks |
