Thread: Want to lower your car? Look in here!!

bullits.

with a 245/45/r17 tire.

did you roll them?

need to.
don't know how.
if its something i could do myself, or do i need a shop to it...

alright guys i know this might be a stupid question but i dont know, how do anti-pogo washers work?

i have ebiach springs with gabriel ultra struts (not installed yet) i bought these struts because there lifetime warranty so i figured when the springs where out the struts i can always get new ones

I think Monroe's website was eff'd, claiming nothing was short, seemed odd. No one will give me their numbers.

I'm thinking about trying to find another car that has coilovers that will fit the fronts. I'm going to look into the Maxima's

Originally Posted by jerZcavy4120

ok. its official.
i need to do something about my rear fenders.
i'm tired of rubbing on EVERYTHING.


help?

take your rear wheels off. using a heat gun, heat up the lip on the fenders until they are HOT to the touch.

use a rubber mallet and bend the lip of the fender up, slowly working your way around so it all goes up at the same time. KEEP IT HOT.

that's seriously all there is to it. that's how i've done all mine. the roller is just 'cleaner', but the hammer method will yield a flatter roll without pulling the fender.

thanks!

i dont think its that hard you just need to use a spring compressor then take apart your struts and put the new lowering springs in

i did my front ones in 15minutes and rear in half an hour. was my first time doing that job too. air tools help

should i run shorter dog bones with my ebiachs?

Originally Posted by gtpeddie

should i run shorter dog bones with my ebiachs?

Nope. Run vinnie spacers instead...check out the community vendors and sell me your eibachs

Sent from my SAMSUNG-SGH-I997 using Tapatalk 2

Originally Posted by REDCOMPG

Nope. Run vinnie spacers instead...check out the community vendors and sell me your eibachs

Sent from my SAMSUNG-SGH-I997 using Tapatalk 2

if i ever get rid of them you can have dibs lol

well i cant run them i dont think because im already gonna have problems with hood clearance and my S2IC

Cradle spacers to help with the height of the SSIC...Zzp sells them. And you wont able to use those shorter dogbones with those fancy headers you acquired.

Sent from my SAMSUNG-SGH-I997 using Tapatalk 2

Originally Posted by REDCOMPG

Cradle spacers to help with the height of the S2IC...Zzp sells them. And you wont able to use those shorter dogbones with those fancy headers you acquired.

Sent from my SAMSUNG-SGH-I997 using Tapatalk 2

fixed lol and i was planning on getting them, i didnt know you couldnt use shorter dog bones with pacesetters

Excuss me fancy pants lol. Yup shorter dogbones are for stock manifolds...any set of headers wont allow short DB. If all else fails with the Vinnie Spacers you dont have to run the full set. You can run a half set if your having clearance issues.

Sent from my SAMSUNG-SGH-I997 using Tapatalk 2

thanks i didnt know that, id have to look into it more the only reason i have clearance issues is because of that damn SD hood