2008 Grand Prix
Base Model
122k miles
Was throwing an ABS, didn't have access to a reader so just did a visual inspection, found wires from pass front where spliced together near the front a-arm bushing, they were very corroded. cleaned everything up joined them back together and problem went away for a while, yay.
A few months back ABS lights back on, drove it for a while this way, then found out neighbor has a reader that does ABS. Threw it on there and told me I had a bad speed sensor front DS, replaced hub cleared ABS code and all is good. A few weeks later it comes back, now complaining about PS speed sensor, replace that hub. All is good. A few weeks later I get it again, but, a different code C0036 from what I have read, this can either be the hub or a wiring issue.
Thinking back to my first issue where I found the splice, did not look factory, but, made me wonder if those are supposed to be spliced, can I expect to have a union near the DS front control arm bushing like the PS?
Tomorrow night I will pull the wheel and see what I find. The connector near the hub, should I put a dab of dielectric grease in that?
Thanks,
John
