I needed to replace the rears and decided Bilsteins would be my solution. It raised the rear a little,maybe .5 inch.
They ride way better. My fronts are good. At the time the front Bilsteins could be had for 210 each but I decided I would just keep tossing FE3s on if there was a problem.
Of course now the front Bilsteins are over 300.
I didn't want the front jacked any higher than it is.
*******IF...you decide to use SSCs you will need trans and engine mount spacers to keep the geometry of the axles.*******
The sudsy picture shows the wheel gap with the Bilsteins in rear, the sig pic is with FE3s
