Thread: My TBSS audio plan... Need lots of help

Progress has been made!

I have purchased a Memphis 1300watt 5 channel amp.... Its a beast! 4x75RMS AB amp, and a full out D amp with 1100 RMS!!! BEAST! I will most likely just run a single little 12in Stype to it for now.. but there is room to grow with this thing.

Also, Picked up a set of polk momo 6.5 components, with carbon fiber cones and some killer little tweeters, and a quite functional configurable crossover.

Need to get a wiring kit, and RCA's, and I should be home free. I may end up with components in the rear doors if I get a wild hair up my ass.

Wiring kit... Yes no?

http://www.amazon.com/Sewell-Gauge-2.../ref=de_a_smtd

Amazon.com: Stinger Pro 3 Series 6 Channel 17 Foot RCA Interconnects: Electronics

its like the prices got mixed up.

if the first is legit, jump on it just for the wiring.

For the connectors you might want something better.

Any suggestions on the RCAs?

I've used non twisted with good success.

If you want top notch stuff: Stereo Cables at Blue Jeans Cable

Pricey though.

If you have a buddy who can get you deals on monster stuff its not bad when you're paying cost + 10%.

Its when you're paying retail that you should be concerned.

Audio has been installed!

Memphis 5 channel 1300 watt amp... wired up 2 alpine stype 12s in the back to 1 ohm total (my ears are bleeding I think). Kicker components up front running off the 5 channel. I have 1 coaxial 3 way in the back door right now, working on installing the other side (factory wiring was borked) also running off the amp.

Sounds downright amazing, has the potential to get way way way too loud at the slightest flick of the gain knob.