|
|
09-25-2011
Got the stereo installed in my gfs brothers car, but now there is no sound. I used a harness i bought from a member here. I have no sound out of the speakers. Im guessing it has something to do with the factory monsoon amp? How do I bypass that amp or get power to it to make it work? Thanks a bunch
btw the car is a 2004 GT2
I found this online..I just need to decipher it to get the amp to turn on
http://crutchfield.custhelp.com/app/...tail/a_id/7098
Last edited by nickleahy23; 09-25-2011 at 01:54 PM.
09-25-2011
Probably need to hook up the amp turn-on wire.
09-27-2011
thanks..after looking at it for a few min, i realized i didnt hook the amp remote to the blue on the harness..never had to do it before...got it taken care of thought...sounds great..I have the 4100 in the tahoe, got him the new 4300..pretty tight
I have one question..I get a loud "pop" when the system shuts off..i read about it online but i cant remember what the fix for it was..
09-28-2011
turn the volume down before turning off
09-28-2011
I believe the pop is the result of the HU turning off while the amp is still powered. The factory HU turns off the amp before it powers down. As far as I know, aftermarket HU's will not have the capability to turn off the factory amp beforehand, so you'll just have to live with it or replace the rest of the system.
I don't know this for a fact, but I have read about it before.
09-28-2011
It could also be a difference of the amp expecting a 5v turn-on vs. the aftermarket radio 12v turn-on. Call crutchfield as a potential buyer but you're concerned about turn-on pop with a DIY install. They'll tell you what resistor to purchase. Local audio shop should tell you as well...probably install it for $10
06-13-2012
I'm trying to install a pioneer avic f900bt and have the same problem. Also what did you hook the power cable for the radio to?
| « Previous Thread | Next Thread » |
| Tags for this Thread |
| Bookmarks |
Bookmarks |
