Thread: Door panel

Results 1 to 6 of 6
  1. #1 Door panel 
    SE Level Member
    Join Date
    Feb 2009
    Location
    chicago
    Posts
    14
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    IS THERE A TRICK TO TAKEN OUT THE DOOR PANEL. I WANT TO REPLACE THE SPEAKERS AND IT SHOWS ME TO USE A 10MM SOCKET. I TRIED BUT THE SOCKET DOES NOT GO ALL THE WAY IN. HOW HAS EVERYBODY ELSE DONE THIS.
     

  2. #2 Re: Door panel 
    Donating Users GeddyLee's Avatar
    Join Date
    Dec 2007
    Location
    St. Louis Mo.
    Posts
    2,573
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    You have to use a Torx bit to remove the two bolts underneath the door handle. There are two caps covering the spots where the torx bolts are. You remove those first, then gently pull from the lower rear corner (towards the trunk of the car) and you will hear the plastic peg holders pop out one by one as you move up the side of the panel and then once you have unpopped those you can slide your hand along the bottom of the door and pop those out until you have gotten all them popped out. Then you pop out the controls in the door and then you can fully remove the panel.

    Not hard actually, just getting the torx bolts back in is a buggar. I recommend magnatizing the torx bit or use something tacky that will help the torx bolt to stay on the bit when screwing them back in.

    James Shafer
    2003 GP GTX SLP P/N 50066 (SOLD )
    2005 Nissan Pathfinder SE 4x4 (The baby hauler )
    St. Louis MO
    1.9 Modified Rockers, TOGs, 180 Tstat, PRJ 10.4 Wires, P/P Gen 3, SLP Ram Air Hood/Wizaired CAI, Gen 1 Spoiler, 3.4 ZZP Pulley, Desert Fox Tranny Cooler, Thrasher Shift Kit, 18" TSW Mondellos w/ AGX Struts, SSC Gen II Springs
     

  3. #3 Re: Door panel 
    SE Level Member
    Join Date
    Feb 2009
    Location
    chicago
    Posts
    14
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    just want to say thanks again.
     

  4. #4 Re: Door panel 
    SE Level Member Hayden's Avatar
    Join Date
    Aug 2008
    Location
    Michigan
    Posts
    83
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    Hmmm. I guess it depends on what year the car is. I have no torx bolts. Just the 2 10mm bolts in the cover on the handle and a few screws along the bottom.
    2008 Grand Prix + Kenwood KVT815DVD, Kicker SXRC Controller, Kicker SX 1250.1, Kicker (2) 12" L7's, Kicker SX 900.4, Kicker RS65.2 Components in front. Infinity Refs 9623i 6X9's in rear
     

  5. #5 Re: Door panel 
    SE Level Member
    Join Date
    Feb 2009
    Location
    chicago
    Posts
    14
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    It's a 2006 and it has two bolts. but the 10mm socket does not fit all the way in. What else can i use to take them out.
     

  6. #6 Re: Door panel 
    SE Level Member
    Join Date
    Jan 2009
    Location
    Michigan
    Posts
    8
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    you have to get a "thin walled socket" to get in there. I had an old cheap socket set that didn't have an actual socket wrench, just a screwdriver handle with a 1/4" socket connection at the end and a selection of metric sockets. Those were thin enough to squeeze down in those holes. I tried 4 different sockets, and only that one was able to get in there and I had to push it a little.

    Generally the higher quality socket sets are have thicker walls on them...which normally is good of course. Makes them stronger and they tend to last longer. Sometimes, these cheapies come in handy though too.
     

Similar Threads

  1. Question to those who have or will have their front int. door panel off
    By mntnbiker in forum Audio, Security & Visual Electronics
    Replies: 4
    Last Post: 06-30-2009, 09:13 AM
  2. How Do I Remove the Left Quarter Panel?
    By y1a3o in forum Off Topic Discussion
    Replies: 3
    Last Post: 05-12-2008, 01:24 PM
Tags for this Thread

View Tag Cloud

Bookmarks
Bookmarks
Posting Permissions
  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •