Activity Stream

The trans originally called for Dex III. I've replaced my trans and used Dex VI and have had no issues other than high mileage. If you keep it in...

232543698178181208

Not sure hooking the charger to the starter is a good idea, but never tried it. If it won't spin over fast enough to start then I would suspect the...

What did the pan/magnet look like? Are there any codes? If you leave the cooler *return* line disconnected, do you see fluid flow?

I just got done replacing 5 solenoids in the trans; shift solenoids, tcc,epc, and mps. I topped off the fluid, but now the car doesn't move at all in...

non bose

Bose or non-Bose? Either way, based on the age of those speakers at this point I'd just check out Crutchfield for replacements and get a nice...

Threw a new pass. side hub and new front brake pads on my brothers 01 GT tonight. Now it's nice and quiet again and stops too, lol. Glad he was...

just buy a HPtuners.

bump =)

You could tap into the wires that power the seat with your preferred 12v source and manually move the motor depending upon which wire is for the...

For better camber adjustment in the rear, slot the TOP strut to knuckle mounting holes. For the front camber adjustment, slot the bottom "strut...

They are working fine.

They are on the airbox behind the dash. They control where the air flows to the vents/defrost/floor and at what tempreature, etc. Since I don't...

you can slot the struts or buy camber bolts. they've got a lobe like a cam does to pull or push the strut in or out. slotting the struts works...

Where would this blend door actuator be located....

Is it a blend door actuator maybe? Not sure what opening the door would have to do with it but they tend to click click click when they are...

i dont have that occur but i have it occur on cold damp/wet mornings. let it run for about 5 minutes, shut it off, fire back up and its good to go.

could be something blower fan related.