What mods would one need to obtain this goal ?
|
|
03-01-2015
What mods would one need to obtain this goal ?
03-01-2015
crank or whp?
:4'' HAI\L67 HVTB\HV3\ER Rockers\WP underdrive pulley\Headers\cat delete\91 octane overkill incar tune.3.69 gears, Trans go shift kit.
03-01-2015
2.6 pulley and a 55 gallon drum of c16 race gas and a 10 lbs bottle of nitrous.
03-01-2015
ported heads, cam and a full size intercooler
03-01-2015
300whp can be had pretty easy. Cam, headers and ic will get you there easy.
03-01-2015
Apparently E85 is all you need for all the horsepowers.
03-01-2015
Cam, headers, e85 should get you north of 320 to the wheels on a conservative tune.
03-01-2015
s1x cam, e85, gen5, 2.8 pulley, headers, 60# injectors, stock heads, stock block. 330whp/400wtq. SIMPLE drama free setup.
03-01-2015
Thats what I'm aiming for in my setup. That and mid 12'sOriginally Posted by 98GrandPrickVet
03-01-2015
damn straight I have a nitrous kit id love to try crack 11.99 on that setup with some DRs or slicks too but its winter im lazy and im going overseas again..... FML..
03-02-2015
You've made the setup have drama... lol
03-02-2015
What is left off the list is a built trans that will handle the newfound HP w/o shredding itself. Take a look at tripleedgeperformance.com for some good ones.
03-02-2015
judging by his other thread, this 300 hp build is going in a Porsche.
03-02-2015
Yes I know I admit I don't drive it very nice all the time, but if you look at it like that its held up pretty decent. Minus the preventive maintenance on the 7/8s chain. (that's my story damn it im sticking to it! LOL) and the whole 3 wheel abortion from my F up. Thank god for full coverage insurance and chalk that mess up to a simple dumb but costly mistake.
03-10-2015
I was wondering if a 3.0 pulley on a gen v with a full stack intercooler, speed daddy headers, 3" cat back exhaust, wizaired cold air, 42.5# injectors, and 1.9 rockers will hit 300hp? Just wondering what ur guys thoughts are
03-10-2015
They should.
03-10-2015
skip intercooler, add xpz cam, and 3.2 pulley and it will also make 300+
03-10-2015
I'm trying to not break into the motor. I know how to build motors just trying to not pull the motor
03-10-2015
None of those mods require you to pull the engine.
Originally Posted by The Sunfire Guy
03-10-2015
How do u swap a cam in a 04+ Gtp without pulling the engine?
| « Previous Thread | Next Thread » |
| Bookmarks |
Bookmarks |
