Does anyone have an idea where to get the bushings for the rear main seal housing.
|
|
03-09-2015
Does anyone have an idea where to get the bushings for the rear main seal housing.
03-09-2015
that's not a bushing it's a glue to hold the bolts in the cover for the assembly line.
03-09-2015
Ok understood. What do I use when putting the housing back in? Or do I not need anything
03-11-2015
usually i just bolt the oil pan on sans gasket and toss two rear cover bolts in just finger snug so the pan holds the pan gasket rails in alignment as you tighten the rear cover slowly and gently as it compresses the paper gasket while tightening in stages with relaxation time in between
03-11-2015
It's not glue. It's a plastic sleeve. I felt it was there to help position the cover better than bolts alone for the rear main.
| « Previous Thread | Next Thread » |
| Bookmarks |
Bookmarks |
