Got myself into a one thing leads to another deal with my 00 GTP.
Started with the input shaft breaking off in my torque convertor.
I didn't pay particular attention to how deep the rear main seal was set into the back cover plate. I put the new one in flush and mocked it up. I didn't like the dust seal was sitting on the chamfer of the crankshaft, so I tapped the seal in a little farther. I got the dust seal riding on the riding surface of the crank, hope the main part of the seal is riding right inside. Opinions from someone familiar with this particular installation? I'm sure it's fine, but you know how it goes.
My after work home this week.:screwup: