so, to summarize.. was it worth the extra cash? or would have SD's been the better choice?
|
|
09-28-2011
so, to summarize.. was it worth the extra cash? or would have SD's been the better choice?
09-29-2011
Yeah Speed Daddy if I had to do it over again. Pay attention and listen to people with experience is all I can say. Both Max and Bill mentioned them before I purchased these.
These headers are not bad by any means but I did buy them thinking there would be no install issues and from there description it sounds like all of the typical header issues such as the trans dip stick would have been addressed if they are the best headers on the market.
09-29-2011
It looks to me like they started with a Pacesetter knockoff header from ebay, used the primary pipes and flange but made their own crossover, rear collector and downpipe. Also rewelded on the outside of the primary to flange and ground the inside welds.
Not a bad way of doing it but I doubt that Mike will be able to rectify some of the issues that Bill is highlighting because they don't make that part of the header.
As for the O2 sensor in the crossover, not been an issue in my experience, and in fact can benefit cams with a lot of overlap that create exhaust reversion because the O2 is further away from the head ports compared to reading from the collector.
| « Previous Thread | Next Thread » |
| Tags for this Thread |
| Bookmarks |
Bookmarks |
