got my Aeroforce the other day and it shows 4.7PST at WOT
the 3.4 set up is supposed to get alot more then that I replaced my all my Vac lines, all new Gaskets
Didnt find a vac leak what else could it be?
|
got my Aeroforce the other day and it shows 4.7PST at WOT
the 3.4 set up is supposed to get alot more then that I replaced my all my Vac lines, all new Gaskets
Didnt find a vac leak what else could it be?
boost bypass valve?
isnt like 9-10PSI normal with a Similar setup to mine?
3.4
DHP PCM
Full exhaust
Headers
MSD ignition
MSD Wires
AL 104's
4'K&N with Wizaired CAI
Ported Supercharged
Ported Throttle Body
9-10 is about right but BBV or vac leak. go, have fun.
It would have to be a HUGE vac leak. Its a the BBV
I think it might be a BBV.....
I'd check Ed Morad first, if he doesn't have one he could probably get one for you in a short time. Other than that, you might try a junkyard where you got all your badges from, just be cautious....
Just bring it over and ill fix it. It is not the bbv, i checked its operation when i put it back on.
Thats why you need to bring it over so i can look at it. Im not going to play guessing games.
My guess is it will take at least 6 beers to fix it. Better just grab him a case.
After installing my Aeroforce, it was showing less boost than the factory boost gauge. I had to set the altitude in my Aeroforce before it was accurate. You probably already did that...but just in case you didn't, you may want to do that.
I dont drink beer...
That only changes your HP and torque readings on the aeroforce.
Boost is read from the PCM which reads from the MAP sensor. Can't really change that.
« Previous Thread | Next Thread » |
Tags for this Thread |