Thread: What pulley size to run with meth?

I'm gathering up parts for my devil's own meth install and am trying to figure out what pulley size to drop to. Right now I have a 3.4", and mods are in my signature. I'm thinking 3.2 - 3.25, what are everyones opinions? Also what to run with it, mixed or 100%? I know Bio, you say 100%, I just wanted some input! Thanks!

I would go 100% and tune and see what pulley you can run with 18-20* timing.

I don't recomend to run 100 % methanol unless you are very famlar with tunning. Yes you can make more power with it but you also have to know what you are doing.

Someone who knows the 100% game will be tuning it for him so it'll be good Rocket

I still say there is a 3.25" in my garage with your name on it

Originally Posted by bluegtp91

Someone who knows the 100% game will be tuning it for him so it'll be good Rocket

I still say there is a 3.25" in my garage with your name on it

Well I started texting Brian earlier and he's trying to convince me to go rockers instead. I'm kinda torn between the two, but either way i'll need that pulley to test out! Rockers will probably benefit me more at this stage, then i can go further to meth injection after the rockers. Now the question... Modded rockers or roller rockers?

roller

i was running a 3.2 on my setup, but never got around to seeing how much timing i could get out of it. i have a feeling that if i would have stayed on the low timing i could have run a 3.0, but also never tried.

i say start with a 3.2 and go down from there.

IF your going to get rockers...go with the new 1.95:1 Roller's and get some Crow #105 Springs/Retainers...

But don't ask for my help on rockers...I dooped mine 2 years ago when I had no experience with these cars and put a few of the pedistals upside down LOL Still ran fine though...minus one rocker popping off

holy ****!! yea dont put them on upside down haha.

my 1.8s made a big diffrence, i wanna see what 1.95s will do.