Doing LIM and Valve Cover Gaskets

Well after weeks of putting it off I finally tackled the LIM. I went ahead and did the valve cover gaskets as well since the back one was leaking. The job overall was not bad if you follow the video posted on this site you should be able to do it. I ran into a couple of issue one BECAREFUL when taking the vacuum lines off as I broke all the rubber pieces so I will be going to Pontiac tomorrow to hopefully by them. The next issue is I can't figure out where this damn plug gets plugged into. It's 3 prongs and has purple around the connector, any thoughts?

http://jimmyslife.com/ebay/gtp/connector1.jpg
http://jimmyslife.com/ebay/gtp/connector2.jpg
http://jimmyslife.com/ebay/gtp/connector3.jpg

Cam position sensor or crank postition sensor
I just looked under my hood and it runs down under the tensioner pulley i believe
Good luck

I just pulled off the coilpack bracket again and I'm not seeing anything done in there. I must be missing something

Coolant temp sensor, on the side of the lim under the throttle body

Bingo 01Gtp nailed it!!!! I would have been looking for that thing for days!!

Thanks

no problem