Thread: PRJ rails and full size IC...

Originally Posted by bluegtp91

That's what I was getting at...they looked pretty big...

I thought AN-6 is what most people use. The lines that come with the rails are AN-6 if I'm not mistaken. I forget what brand hose they are made of, but they have the lining inside the hose to prevent outgassing.

yea, youre right everyone uses -6 an which is 3/8" , same as factory.

Iron Indian, are you lowered? I've got the GMPP/Koni setup and the ZZP offset polys. I'm wondering if I'll have any issues with the full IC and hood clearance. I'm sure I'll need the cradle spacers.

BTW, that custom tensioner is pretty bad ass.

i run cradle spacers, although i might not need to now, only had a problem with my original intercooler, was 2.5 inches high, since then have made them 2.25 inches tall.

Originally Posted by Iron Indian

I'm stock ride height. I personally don't have hood issues with my slightly taller aftermarket hood. Besides, my core is 2.00" tall which helps.

The offset mount may cause issues with clearance if you're gonna run a ZZP style core which is 2.25" tall under a stock hood.

Thanks for the info. I'll probably have to run cradle spacers. Not sure how that will affect my axle geometry with me being lowered and having offset mounts. Maybe I'll be eating up axles like no tomorrow.

yea, probably wouldnt advise that, youll be good with a 2.25 inch core i promise.

Originally Posted by minichopper6hp

yea, probably wouldnt advise that, youll be good with a 2.25 inch core i promise.

Well, offset mounts is the equivalent of raising the motor. The cradle spacers would lower the motor. So technically, the axle geometry would really be pretty close to stock. I may just have to end up selling the offset mounts and running a set of regular poly mounts.

you probably wont need cradle spacers. which core are you gonna run?

Originally Posted by minichopper6hp

you probably wont need cradle spacers. which core are you gonna run?

Your full ic.

yea, you should be fine, it measures 2.25 inches so i see no problem with it, but you never know, every car is different. if not, i sell cradle spacers as well, $20.