machined open inletshave to blend it still but i thought i would share...
|
|
05-26-2009
machined open inlets
Last edited by minichopper6hp; 05-26-2009 at 02:53 PM.
05-26-2009
nice...now put some aluminum epoxy in all the holes minus the BBV.
05-26-2009
plan on it
05-26-2009
cutting out the v right now.
05-26-2009
Found it. LOL
05-26-2009
well, what do you think?
05-26-2009
I like it. Those pics look a lot better than those other ones you sent me too. LOL
What I did to my last one was sand the inside down with some 1000 grit. It was like glass when I was done. I think it turned out good.
05-26-2009
im workin on it.
05-26-2009
what was wrong with the other ones, they were progress pics. at that point i had not smoothed the inlet. right now i have the inlet 90% smoothed out now, just machined the inlet to 76 mm as in the photos and as of now im putting a v 45 degree cut on the outlet.
Ill post pics. I might be offering these for sale also, you will get for $150, outlet work, inlet work, snout machined for smaller pulley and powdercoated color of choice, red,black,yellow,white,blue. More colors can be ordered upon request, i just stock those normally. can also put in new bearings and seals for extra.
Last edited by minichopper6hp; 05-26-2009 at 04:32 PM.
05-26-2009
that's a good deal for that much work on it. do you plan on taking out the h-bar too?
05-26-2009
que??Originally Posted by minichopper6hp
05-26-2009
^^^ added pics
05-26-2009
put a 45 degree cut on the V outlet, just like zzp does. Helps with exiting air to reduce temps.
05-26-2009
I gotcha now, basically beveling the edge. I thought you were talking about a new cut or something.
05-26-2009
bump
05-27-2009
so, does anyone sound interested?
| « Previous Thread | Next Thread » |
| Tags for this Thread |
| Bookmarks |
Bookmarks |
