|
|
09-03-2018
I have the steel oil pan with the 'U' like engine bracket... Which bracket do I have to use other than #2?... Also looking to upgrade #4 to Poly Motor Mounts.
Do I absolutely have to use the bracket that goes in between differential cover/oil pan (#1)?
And do I have to use the bracket that goes in front (#3)?
Just need to know because I know 04 GTP's is a weird yr.
Sent from my SM-N950U using Tapatalk
09-05-2018
#2 is correct
As for the diff to oil pan bracket, I'd recommend it. the transmission casing is reinforced by that bracket. Have I done an install on my car and forgotten the bracket around midnight? Yes I had. When I did the trans again another month later I added it back in w/o any negative issues. I'd always put it in when doing a trans. Always do the backwards bolt too, cause it's way easier than people make it out to be.
09-05-2018
Ok, that's good to know. I left it at the yard thinking I wouldn't necessarily need it but I'll grab it. Thanks for the response Billboost
Sent from my SM-N950U using Tapatalk
09-06-2018
You could also use a 97-03 one... it'll go to the engine instead of the pan. Personally I always thought it was an easier bracket to install/remove. That's only because I did a billion more of them vs the 04 plus though.
09-06-2018
How does the 97-03 look? Would rather bolt up to the engine instead of the pan
Sent from my SM-N950U using Tapatalk
09-06-2018
09-07-2018
Did more inspecting on my 04 GTP and I do have that same bracket that's shown in your picture. So I should good with just that 1 engine mount to oil pan bracket?Originally Posted by BillBoost37
Sent from my SM-N950U using Tapatalk
09-06-2018
Interesting thing here is the engine block is the same S2 vs S3 and the trans is the same at the diff where the bolts go. Not sure why GM changed it from going to the engine to the oil pan. You can use either bracket though. If you change to the older bracket, make sure you get the bolts too as they are different.
09-06-2018
Yeah, that's a waaaay better set up and waaaay easier to access. I'll be going after that bracket tomorrow AM. Thanks for the pics!
Sent from my SM-N950U using Tapatalk
09-08-2018
When you swap the pan.. just leave that bracket alone. You don't have to remove it to get the old engine mount horseshoe bracket off.
My Regal had the aluminum oil pan and the older style trans to engine bracket shown in my last post.
09-09-2018
Yeah, I see exactly what you're saying. Thanks!... The 06 GTP threw me off how that bracket set up was. I had to remove the oil filter neck to take the bracket out. Weird ha
Sent from my SM-N950U using Tapatalk
| « Previous Thread | Next Thread » |
| Tags for this Thread |
| Bookmarks |
Bookmarks |
