So yea, I've been working on this gen 5 I got from the u pull it lot. Porting and polishing the inlet and wat not and decided to take the bypass valve out of its hole, in order to get a good finish on the wall that is vertical above it. Fastward Done doing that or whatever lol and now it's time to put the valve back in the hole and It does sIt flush in hole at all as it once did. Theres a gap around one side of the valve that screams Haha ***** less boost for you! I'm ready to never deal smh. The only thing I did to that hole was take a dremel size wire brush to it in purpose to clean all the carb out. I swear I didn't remove any metal! ..at least I hope I didnt. If i did i suck. But I'm asking you guy's help in Hope's that maybe I'm putting back in there in the wrong orientation. I noticed theres a small "f" on one side of the valve and did some image searching. im guessing this means face up??? F**k up??? Facetime??? Iono smh . Trying to really fix this soon. The sc on my car has one bad needle case bearing and I'm down on power so much I got beat by a senior citizen in Audi 2.0 T. She gave me a nice smile while she was beside me and then drove out of my life felt like I was in a Scion tC
