Hey everyone.
Went to go do my wires and plugs today. Like a sucker, I started with the front 3. No problems here, obviously.
Next was the rear 3. I undid the dog-bones and tilted the engine forward a smidge. Great access compared to other v6s I've done. But then I went to try and get the wires off, and they are routed under the casting that holds the dog-bone in place on the passenger side. I looked to see if it can be removed, and its not going anywhere without a fight.
Am I looking at this wrong? I have half a mind to cut the wires and just route the new ones over the valve cover, instead of where they run now.
Anyone have any pointers??
Thanks
t
