Thread: 98 Gt with P0108 code

P0108 is a MAP sensor, not the MAF.

The MAP (Manifold Absolute Pressure) sensor measures engine manifold negative air pressure. It's usually a three wire sensor: a ground wire, a 5 volt reference wire from the PCM (Powertrain Control Module) to the MAP sensor, and a signal wire that informs the PCM of the MAP sensor voltage reading as it changes. The higher the engine vacuum, the lower the voltage reading. The voltage should range between about 1 volt (at idle) to about 5 volts (WOT wide open throttle).
If the PCM sees the voltage reading from the MAP sensor is greater than 5 Volts, or if the voltage reading is higher than what the PCM considers normal under certain circumstances, a P0108 DTC will set.

i would replace the sensor and the gromet, or o ring also the pcv is nder the map, get one of them too

Most other sensors are cheaper than the maf.