Thread: Mass air flow sensor bad??

Results 1 to 9 of 9
  1. #1 Diagnostic help! Bad MAFS??? 
    SE Level Member fuzzbutt's Avatar
    Join Date
    Jan 2011
    Location
    fallbrook
    Posts
    13
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    We have a 1998 3800 automatic and it has a bad stutter/lurching at 2kRPM or under when constant throttle and under load (i.e. a hill of any sort). I've replaced the Throttle Position Sensor, fuel filter, PCV, checked air filter, changed plugs, etc. Can this be a symptom of a bad Mass Air Flow Sensor?? If so, I need to find the thread for replacing it. if not, then I'm outta ideas!

    Thanks!
    Reply With Quote  
     

  2. #2 Re: Diagnostic help! Bad MAFS??? 
    GrandPrix Junkie CTKGP09's Avatar
    Join Date
    May 2009
    Location
    Willoughby, Ohio
    Posts
    3,831
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    yes a MAF could cause symtoms like that as well as a vacuum leak, does the SES light come on or flash?
    '04 Chevy Silverado LT 4x4 - intake, headers, full exhaust, zo6 cam, 799 heads, tune, leveled, 33's
    '00 Grand Prix GTP DAYTONA 500 - L36 block, S1X, intercooled, GenV, N*, headers, full exhaust, coilovers, 5 speed swap, stage 3+ clutch
    Reply With Quote  
     

  3. #3 Mass air flow sensor bad?? 
    SE Level Member fuzzbutt's Avatar
    Join Date
    Jan 2011
    Location
    fallbrook
    Posts
    13
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    We have a 1998 3800 automatic naturally aspirated that lurches/chugs only when at 2000RPM or lower at steady throttle when under a load (i.e. any hill). I've replaced the Throttle Position Sensor, fuel filter, plugs, PCV, air filter but to no avail. Can this be a MAFS? If so, where can I find a thread to replace it? If not, any ideas??

    Help!

    Thanks!
    Reply With Quote  
     

  4. #4 Re: Mass air flow sensor bad?? 
    Perma-Banned! JK LOL Explicit_Spade's Avatar
    Join Date
    Dec 2007
    Location
    Omaha, NE
    Posts
    7,921
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    Is your check engine light on?
    Quote Originally Posted by W-Body Store
    Remember, GM engineers didn't take into account your need for speed.
    Daily Driver: 06 Grand Prix GT / 9.4:1 CR / IS3 Heads / Ported Gen V / ZZP Headers / HPT Pro / Pulleys: 4.25, 3.8, 3.5, 3.4, 3.2, 3.0, 2.9, 2.7
    Projects: 86 Monte Carlo SS / 98 Sonoma / 74 Honda CB750
    Reply With Quote  
     

  5. #5 Re: Diagnostic help! Bad MAFS??? 
    SE Level Member fuzzbutt's Avatar
    Join Date
    Jan 2011
    Location
    fallbrook
    Posts
    13
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    No lights come one and I've checked for any codes but nothing has shown. Can't determine any air leaks by spraying WD40 around most intake tracts, etc. so I'm thinking MAFS unless another good option is available. How much is a MAFS and how long will it take to replace? any special tools (these stupid Torx screws suck- most tool dept.'s have the Torx screwdrivers but not with the little stud in the middle!). Any threads for replacing the MAFS? I can't find the search option here.

    Thank you.
    Reply With Quote  
     

  6. #6 Re: Diagnostic help! Bad MAFS??? 
    GTP Level Member
    Join Date
    Oct 2011
    Location
    Raleigh, NC
    Posts
    791
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    Quote Originally Posted by fuzzbutt View Post
    No lights come one and I've checked for any codes but nothing has shown. Can't determine any air leaks by spraying WD40 around most intake tracts, etc. so I'm thinking MAFS unless another good option is available. How much is a MAFS and how long will it take to replace? any special tools (these stupid Torx screws suck- most tool dept.'s have the Torx screwdrivers but not with the little stud in the middle!). Any threads for replacing the MAFS? I can't find the search option here

    Thank you.
    Those are called security torx screws, Harborfreight has a set of drivers for $5.00
    1997 Red GTP 182000 miles stock
    Reply With Quote  
     

  7. #7 Re: Mass air flow sensor bad?? 
    DUI BABY Bio248's Avatar
    Join Date
    Jan 2008
    Location
    MILWAUKEE
    Posts
    31,340
    Thanks (Received)
    0
    Likes (Received)
    1
    Dislikes (Received)
    0
    merged. please do not post more than one thread about the same subject.
    Reply With Quote  
     

  8. #8 Re: Mass air flow sensor bad?? 
    SE Level Member
    Join Date
    Jan 2012
    Location
    FT Campbell, KY
    Posts
    134
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    Sounds similar to the problem I'm having with my RWD L36. If I've been at a cruise and drop it into neutral I will stall. If I "push-start" by going back into 4th or something, the car'll restart and be just fine until I do it again. Downshifting until I'm at the bottom of 2nd will keep the car from stalling. I've done the fuel filter and air filter. I'm throwing no codes and have none in memory. Any ideas?

    Colleen
    : CAI, HV3, 2.5" d/p w/h/f cat. Full suspension, PowerSlots w/Hawk HPS, GR2s, Sonar projectors. Needs tune. Awaiting install of FBod brakes.
    Shianne: 98 L36 MM5. Good start to a LONG project.
    Reply With Quote  
     

  9. #9 Re: Mass air flow sensor bad?? 
    SE Level Member fuzzbutt's Avatar
    Join Date
    Jan 2011
    Location
    fallbrook
    Posts
    13
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    Oops, sorry for double posting- my bad. Okay, so I'm not convinced it's a MAFS, as most of the other threads with bad MAFS had symptoms like engine dying, rough idle, etc.

    No SES lights, no codes, nothing!

    This is only one specific issue, when the car is under load at or under 2000 RPM ONLY. It lurches and stutters. Could this perchance be a transmission problem? Searching or slipping for the right gear? It doesn't feel or sound like a slipping gear- no change in RPM, no noise from the tranny, etc. Since it doesn't happen at 2K RPM on the flats, no load, then why would it be a fuel or air issue? Nothing is different at 2K RPM except under load, right? So, what else could it be? I'm so frustrated I could ****...

    :O

    3.8L naturally aspirated automatic SE, 111K miles
    Last edited by fuzzbutt; 01-04-2012 at 09:00 PM.
    Reply With Quote  
     

Similar Threads

  1. mass air flow sensor?
    By Bakerdd in forum 3.8L V6 Naturally Aspirated (L36)(L26)
    Replies: 9
    Last Post: 04-27-2012, 10:35 AM
  2. Mass air flow sensor
    By Logan541 in forum General Tech Discussion
    Replies: 2
    Last Post: 11-11-2011, 06:24 PM
  3. mass air flow sensor?
    By tcafego in forum 3.8L V6 Supercharged (L67)(L32)
    Replies: 9
    Last Post: 09-02-2011, 10:47 AM
  4. Mass Air Flow Sensor
    By msh227 in forum General Tech Discussion
    Replies: 1
    Last Post: 10-19-2010, 11:39 AM
  5. Mass air flow sensor
    By duane9586 in forum 3.8L V6 Supercharged (L67)(L32)
    Replies: 8
    Last Post: 08-03-2008, 01:36 PM
Tags for this Thread

View Tag Cloud

Bookmarks
Bookmarks
Posting Permissions
  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •