|
I updated my picture on the first page to represent moreso what one of our cars should look like under the hood instead of missing an engine mount and insane wire routing.
wait...I thought our cars were supposed to be missing a mount and have crazy wiring...XD
I ordered the same filter and rubber hose that he has. i think im going to put that little sensor on the back side so you can't see it so it is very clean. does that make sense. what do you think of that look......I wish my engine bay was that clean though. I also wish I had a shinny supercharger strapped to the top
XD, you should be fine, the only problem I can see you having is trying to get the IAT wire to reach back there, as it's not a very long wire to begin with. But I would kill to have my fuel rails like his, and that fuse box cover too
ooooooooooooooo I know it looks so good. I think ill do it either way just so that it is just that much cleaner
Clean engine bays are for people who dont spend enough time driving their car
That should be fine. I take it you're going with a bigger filter then? Can't really see the whole length of it.
Ya i think it is going to be a bigger filter I think I'm ok with that though. give me a min Ill post a link to specs.
21-2049DK Product Specifications
Product Style: AEM Dryflow Conical Air Filter
Base Outside Diameter: 6 in (152 mm)
Flange Inside Diameter: 3.5 in (89 mm)
Flange Length: 1.375 in (35 mm)
Flange Type: Centered
Height: 8.938 in (227 mm)
Inner Structural Support: Yes
Top Outside Diameter: 5.125 in (130 mm)
Top Style: Rubber
Top Material/Finish: None
Filter Material: Non-woven Synthetic
Weight: 1.4 lb (0.6 kg)
Product Box Length: 12 in (305 mm)
Product Box Width: 8 in (203 mm)
Product Box Height: 8 in (203 mm)
I vote 4" ID but thats just me.
buy it from nick/01gtp, he should be able to get you good prices.
ehhh I ordered it already. its half way here from cali.. i just want to get it I dont really care that I spent a couple extra bucks right now
I got my pipe in. now I am just waiting on the filter.
how hard is it to take that throttle off to paint it black? I dont like the way it looks right now at all and I thought a nice glossy black might be nice. kinda like in the pic above
three nuts, pretty easy. You'd need a new TB gasket though.
you only need one gasket : \
I know but when I replaced the upper plantum I replaced that gasket and it came in a kit of all of the gaskets. do you think that I could just buy that one
yeah. not sure if your parts store can get it or if you'd have to go to the dealer. Check both out. Personally GM gaskets are worth the small extra cost.
Engine enamel should be good.
« Previous Thread | Next Thread » |
Tags for this Thread |